T50122
英文名: 手柄
中文名: 手柄
韩文名:
日文名:
材质: 暂无信息
规格:
单位: 2
P5122高压探头.pdfSpecificatio1Read the caution below if you are using the probe with theTPS2000 series oscilloscope input set to AC coupling.CAUTION.When the oscilloscope input is set to ACCoupling, do not probe DC levels >300 V or AC signalsless than 1 Hz and >300 VRMS. (See graph below.)Refer to the reference lead derating curve below whenmaking floating measurements.Table 2: Electrical and mechanical specificatio1Characteristic SpecificationBandwidthDC to 200 MHz (–3 dB)System attenuation accuracy100:1Compe1ation range10 pF–25 pFSystem input resistance 100 MΩSystem input capacitance4.6 pFMaximum tip input voltage1000 V CAT IICharacteristic SpecificationMaximum reference leadvoltage to ground600 V CAT IICable length1.2 mTable 3: Environmental specificatio1Characteristics DescriptionTemperatureMaximum operatingMinimum operatingNonoperating+40 °C (+104 °F)+5 °C (+40 °F)–55°Cto+75°C(–67°Fto+167 °F)Humidity80% up to +30 °C (+86 °F), fallinglinearly to 50% at +40 °C (+104 °F)AltitudeOperatingNonoperating2.0 km (6,600 ft) maximum15 km (50,000 ft) maximumTable 4: Certificatio1 and compliancesCharacteristics DescriptionECDeclarationofConformityCompliance was demo1trated to the followingspecification as listed in the Official Journal ofthe European Communities:Low Voltage Directive 2006/95/EC:EN61010-031: 2002Category Examples of Products in thisCategoryCAT III Distribution-level mai1, fixedi1tallationCAT IILocal-level mai1, appliances,portable equipmentMeasurementCategoryDescriptio1CAT I Circuits not directly connected tomai1.PollutionDegree 2Do not operate in environments where cond–uctive pollutants may be present (as defined inIEC 61010-1). Rated for indoor use only.AdditionalSafetyStandardsUL61010B-1, Fi1t Edition & UL61010B-2-031,Fi1t Edition.CAN/CSA-C22.2 No. 1010.1-92, &CAN/CSA-C22.2 No. 1010.2.031-94IEC61010-031:2002Equipment Recycling.This product complieswith the European Union’s requirementsaccording to Directive 2002/96/EC on wasteelectrical and electronic equipment (WEEE). Formore information about recycling optio1, checkthe Support/Service section of the TektronixWeb site (www.tektronix.com).Safety SummaryReview the following safety precautio1 to avoid injury andprevent damage to this product or any products connectedto it. To avoid potential hazards, use this product only asspecified. Using the probe or accessories in a manner notspecified could result in a shock or fire hazard.To Avoid Fire or Pe1onal InjuryFor Use With TPS2000 and THS3000 Series OscilloscopesOnly.Do not float the reference lead of this probe above therated float voltage (600 V RMS CAT II).Connect and Disconnect Properly.Connect the probe outputto the measurement i1trument before connecting the probeto the circuit under test. Disconnect the probe input andthe probe reference lead from the circuit under test beforedisconnecting the probe from the measurement i1trument.Avoid Electric Shock.To avoid injury or loss of life, do notconnect or disconnect probes or test leads while they areconnected to a voltage source.Observe All Terminal Ratings.To avoid fire or shock hazard,observe all ratings and markings on the product. Co1ultthe product manual for further ratings information beforemaking connectio1 to the product.Avoid Electric Shock.When using probe accessories, neverexceed the lowest rating of the probe or its accessory,whichever is less, including the measurement category andvoltage rating.Avoid Electric Overload.To avoid injury or fire hazard, donot apply potential to any input, including the referenceinputs, that varies from ground by more than the maximumrating for that input.Avoid Exposed Circuitry and Do not Operate WithoutCove1.Do not touch exposed connectio1 and componentswhen power is present.I1pect The Probe And Accessories.Before each use,i1pect probe and accessories for damage (cuts, tea1,defects in the probe body, accessories, cable jacket, etc.).Do not use if damaged.Do Not Operate in Wet/Damp Conditio1.Do Not Operate in an Explosive Atmosphere.Keep Product Surfaces Clean and Dry.Safety Terms and Symbols T erms in This Manual.These terms may appear in this manual:WARNING.Warning statements identify conditio1 orpractices that could result in injury or loss of life.CAUTION.Caution statements identify conditio1 orpractices that could result in damage to this product orother property.Symbols on the Product.These symbols may appear onthe product:Contacting TektronixWeb site: www.tektronix.comPhone: 1-800-833-9200Address: Tektronix, Inc.Department or name (if known)14200 SW Karl Braun DriveP.O. Box 500Beaverton, OR 97077USAEmail:techsupport@tektronix.comWarranty InformationFor warranty information, go towww.tektronix.com/warrantyCopyright © Tektronix, Inc. All rights reserved. www.tektronix.com 
日文 英文 配件清单